Chapter 6. Measurement Mode

Chapter 6. Measurement Mode
Prev		Next

Table of Contents

6.1. Starting Measurement Mode

6.2. Analog Scan Mode

6.2.1. Purpose of the Analog Scan Mode
6.2.2. Analog Scan Mode User Interface

6.3. Analog 3D Scan Mode [Experimental]

6.3.1. Purpose of the Analog 3D Scan Mode
6.3.2. Analog Scan 3D Mode User Interface

6.4. Digital Scan Mode

6.4.1. Purpose of the Digital Scan Mode
6.4.2. Types of Spectroscopy Measurements
6.4.3. Digital Scan Mode User Interface
6.4.4. Executing Digital Scan
6.4.5. Handling Digital Scan Output Data

6.5. Approach Mode

6.5.1. Purpose of the Approach Procedure
6.5.2. Approach Types
6.5.3. Approach Sequence
6.5.4. Feedback Handling on Entering and Leaving Approach Mode
6.5.5. Manual versus Automatic Approach
6.5.6. Approach User Interface

6.6. Capacitive Approach Mode

6.6.1. Purpose of the Capacitive Approach Procedure
6.6.2. How the Capacitive Approach Procedure Works
6.6.3. Approach User Interface

6.1. Starting Measurement Mode

You can switch from analysis mode to measurenment mode via Mode → Measurement Mode.

Note that before you do this, you must first select the proper interface DLL via Settings → Hardware... and create a project for your measurements via Project → New Project.